Message 29665 in TECH.WW
From: G8MNY
Date: Wed, 09 Sep 26 09:41:00 Z
Newsgroups: TECH.WW
Subject: VCR Triplexer to TV Input
Message-ID: <4576_GB7CIP>
Path: N2MH4|VE3KPG|GB7CIP
R:260909/0947Z 36877@N2MH4.#SENC.NC.USA.NOAM LinBPQ6.0.24
R:260909/0946Z 500@VE3KPG.#ECON.ON.CAN.NOAM BPQ6.0.25
R:260909/0941Z @:GB7CIP.#32.GBR.EURO #:4576 [Caterham Surrey GBR] $:4576_GB7CIP
From: G8MNY@GB7CIP.#32.GBR.EURO
To : TECH@WW
By G8MNY (Corrected Mar 06)
(8 Bit ASCII graphics use code page 437 or 850, Terminal Font)
LA6EAH asked for a circuit to feed 3 RF signals from VCR to a TV..
With the systems options below if there is an external aerial, then 2 clear RF
channels are needed per modulator, as they are normal AM not VSB. Also check on
digital TV signals as these often appear as just high noise on your VCR
channel!
If you can check on a spectrum analyser, you will clearly see how good or poor
the setup is...
Strong
8MHz ch 1ch +2 dirty ch! 2 channels + products
NORMAL V.S.B. TV C.O.F.D.M. DIGITAL TV D.S.B. (AM) VCR OUTPUT
It is easy to put the wide VCR output over a wanted channel, or have a digital
channel under the chosen VCR channel seen as noise on the VCR output.
Also amplifying a digital signal before the Rx often leads to corruption of the
digital signal, as amplifiers have to be VERY LINEAR to handle the weak digital
signals in the presence of stronger analogue signals.
OPTION 1 The normal way
3-6dB 3-6dB
Because most VCRs have 3-6dB RF gain in their aerial isolating amplifiers,
attenuators are often needed, so that the following VCRs are not overloaded
with the sometimes stronger modulator outputs. Some older VCRs have local-
distant switches to help improve their sensitivity and through linearity.
The attenuators can just be made up of the thin lossy leads you normally get
with the VCRs!
There are no losses in this system just RF amplifier problems.
OPTION 2 The abnormal way
The combiner can be any of several types:-
using 2 x low loss (3.5dB ea) standard splitters, although matching is dubious!
3.5dB loss (o)_________________________
or a dedicated 3 way resistive splitter eg. 4x 39R in a star network properly
matched to 75R.
(o)-39RĿ
or slightly less loss with a dedicated matching ferrite bead transformer.
OPTION 3 The switch way
Good switches at UHF are rare! Most have 1-2dB insertion loss and only 20dB
isolation.
Why Don't U send an interesting bul?
73 de John G8MNY @ GB7CIP
← Return to Bulletin List